Cylinda DM8330 FI, User Manual

Page: 29 / 44

TID - Time remaining
Once you have chosen a programme and options, the time
the programme took when last used is displayed.
Status light
The status light on the bottom part of the dishwasher indic-
ates that a programme has started.
Flashing light
This indicates a fault. See further in the section
Troubleshooting.
Status light
Stopping or changing a programme
If you want to change programme after starting the dishwash-
er, open the door then press and hold the main power switch
until the display turns off. Add more detergent if the lid of
the detergent dispenser has opened. Then press the main
power switch, choose a new programme and close the door.
If you want to load more dishes
Open the door. The dishwasher stops automatically. Add
the dishes and close the door. After a while, the dishwasher
continues the programme.
If the dishwasher is turned off due to a
power failure
If the dishwashing programme was not finished, the inter-
rupted programme continues when power is restored.
NOTE!
During drying, the programme is interrupted if the power
is cut or the door is open for more than 2 minutes.
Once the programme has finished
Moreover, the end of the programme is indicated by the
status light turning off. See Status light in the chapter Using
the dishwasher.
The dishwasher switches off automatically after the pro-
gramme ends. Shut off the water tap after each use.
How to get the best drying results
•
Fully load the dishwasher.
•
Angle dishes with hollows, such as cups, so that the
rinse water will run off. This is also important for plastic
items.
•
Top up with rinse aid or increase the rinse aid dosage
level.
•
Activate the Auto open option.
•
Activate the HI DRY option.
•
Allow the dishes to cool before unloading the dishwash-
er.
Unloading the dishwasher
Hot porcelain is more fragile. Leave the dishes to cool in
the dishwasher before unloading them.
Unload the lower basket first to avoid any water drops from
the upper basket falling onto the dishes in the lower basket.
Special programmes
Self-cleaning programme (CLn)
Press and hold the associated option buttons to activate a
special programme. The programme starts when the door
is closed.
Self-cleaning programme (CLn)
Self-cleaning programme for hygienic cleaning of the dish-
washer tub, spray arms and spray pipes.
This programme should be run (with no dishes in the ma-
chine) using normal dishwasher detergent or citric acid.
Special dishwasher cleaners are also available on the
market. For the removal of limescale deposits, see The
dishwasher tub in the chapter Care and cleaning.
29
EN