Cylinda DM8330 FI, User Manual

Page: 33 / 44

Care and cleaning
Top up with rinse aid
When the rinse aid needs topping up, the above symbol
lights on the display.
Press to open
1. Open the rinse aid compartment lid.
2. Carefully top up with rinse aid to the level marked
max .
3. Wipe up any splashes of rinse aid around the compart-
ment.
4. Close the lid firmly.
After topping up, it may take a while before the symbol goes
out.
Top up with salt
When the salt needs topping up, the above symbol lights
on the display.
Salt compartment lid
When the salt runs out, unscrew the cap and fill the contain-
er with salt. Water is only needed the first time! Wipe clean
and tighten. Run a programme to ensure that any salt in the
dishwasher is rinsed away.
After topping up, it may take a while before the symbol goes
out.
WARNING!
In order to avoid rust stains a dishwashing programme
must be started immediately after adding salt.
Never pour dishwasher detergent into the salt compart-
ment. This destroys the water softener!
Coarse filter
The coarse filter traps larger food particles, which cannot
get past the drainage pump. Empty the coarse filter when
necessary.
Coarse filter
1. Lift the coarse filter by the handle.
2. Empty the coarse filter. Remember to refit it!
Fine filter
Debris that collects on the fine filter is automatically rinsed
away during each wash. Clean the fine filter when neces-
sary.
Fine filter
1. Turn the handle anticlockwise.
2. Lift the filter straight up using the handle. Free the coarse
filter to clean the fine filter.
3. Refit in reverse order. Check that the edges seal prop-
erly when refitting the fine filter.
4. Lock the filter in place by turning the handle clockwise
to the stop position. The handle should point straight
out from the dishwasher.
NOTE!
Dishwashing results may be
affected if the filters are incorrectly
fitted. Note that the dishwasher
must not be used without the filters
in place!
33
EN