BHSCS
D
B
7. Install new rear leg on frame.
A.
Place grease on the new pivot pin assembled
in step 6B. See Figure 3.
B.
Place the new rear leg (A) so that the pivot
hole aligns with the holes in the frame. See
Figure
3.
C.
Insert new pivot pin assembly. See Figure 3.
D.
Install the other BHSCS/loctite, new spacer
(E) and new plastic end cap (D) to the pivot
pin (B) and tighten using two 7/32” Allen
wrenches as shown in Figure 3.
NOTE:
Instead of installing these new parts, you
can install the old aluminum end cap.
8. Install the BHSCS/loctite, new spacer and
new end cap.
A.
Place a drop of loctite (F) on the BHSCS
(removed in step 3A) and another drop
inside the shaft into where the BHSCS
will be tightened.
B.
Using a 7/32” Allen wrench, reinstall the
BHSCS/loctite (removed in step 3A), new
spacer (E) and new end cap (C). See
Figure
2.
NOTE:
Instead of installing
these new parts, you can reinstall the
old aluminum end cap.
C.
Tighten securely.
9. Test for proper operation.
Figure 5
5. Install new rear leg on the foot bar.
A.
Place grease on the outside of the foot bar
shaft. See Figure 4.
B.
Place the new rear leg (A) into position on the
foot bar.
6. Assemble
pivot
pin.
A.
Place a drop of loctite (F) on the two BHSCS
removed in step 4A and another drop inside
the new pivot pin (B) shaft where the two
BHSCS will be tightened.
B.
Install one BHSCS/loctite, a new spacer (E)
and new plastic end cap (D) to one side of the
new pivot pin (B). See Figure 5.
NOTE:
Instead of installing the new end cap
and spacer, you can install the old aluminum
end cap to the new pivot pin.
A
Figure 4
Grease
Loctite
Foot Bar
E
Loctite
Cybex® and the Cybex logo are registered trademarks of Cybex International, Inc.
Arc Trainer® and its mark are registered trademarks of Cybex International, Inc.
10 Trotter Drive Medway, MA 02053 • 508-533-4300 • FAX 508-533-5183 • www.cybexinternational.com • [email protected]
[email protected] • Copyright © 2008, Cybex International, Inc. All rights reserved • 425A-501 B • March 2008
Summary of Contents for Arc Trainer 425A
