4. Configuration
4.1 Initial Configuration
If DHCP mode is enabled (IP auto configuration = DHCP), the GFC IPM switch will try
to contact a DHCP server in the subnet to which it is physically connected. If a DHCP
server is found, it may provide a valid IP address, gateway address and net mask.
Before you connect the device to your local subnet, be sure to complete the
corresponding configuration of your DHCP server. It is recommended to configure a
fixed IP assignment to the MAC address of the GFC IPM switch. You can find the MAC
address labeled on the bottom side of the metal housing.
If DHCP mode is disabled (IP auto configuration = None), the factory default IP
settings are as below:
IP address
192.168.1.22
Subnet mask
255.255.255.0
Default Gateway
None
Table 4-1 Initial Network Configurations
GFC IPM switch Setup Tool
If this initial configuration does not meet your local requirements, use the setup tool to
change the configurations to your needs. The setup tool
PSetup
can be found on the
CD ROM delivered with this package. You can follow the procedures described below.
3. DHCP
If you have installed the GFC IPM switch on a network that enables DHCP, you can
use the
PSetup
to find out the GFC IPM switch’s IP.
(1) Plug Ethernet cable to GFC IPM switch. GFC IPM will get an IP via DHCP.
(2) Using
PSetup
(run PSetup.exe) to look for GFC IPM.
a. Select MAC address which label on bottom of GFC IPM switch
b. Click
Query Device
Notes:
BOOTP
, a static configuration protocol, uses a table that maps IP
addresses to physical addresses.
DHCP
, an extension to BOOTP that dynamically assigns configuration
information. DHCP is backward compatible with BOOTP.
GFC IPM
CyberResearch
®
KVM Accessories
14
©Copyright 2009
CyberResearch, Inc.