CyberPower CPSPI3700EVF380, User Manual

Page: 46 / 94

Parameter Name Description Setting Range
0 : Reverse Disabled
1 : Reverse Enabled
b5-11
PID Feedback Low
/High Detection
Selection
0
∶
Multi-Function Output Only
1
∶
Feedback Low /High Alarm
The controller continues operation when an
alarm is displayed)
2
∶
Feedback Low /High Fault
A fault will cause the controller to stop the
load.
3
∶
Multi-Function Output only when PID is
Disabled
Same action as b5-11=0.
4
∶
Feedback Low /High Alarm (detection
disabled when PID is disabled)
5
∶
Feedback Low /High Fault (detection
disabled when PID is disabled)
6 : Multi-Function Output (Keep running without
an alarm displayed)
7 : Multi-Function Output Only (detection
working when controller running or not)
Default
∶
0
Min.: 0
Max.: 7
b5-12 PID Feedback Low
Detection Level
Sets the PID feedback level used for detection.
When the PID feedback falls below this level for
longer than the time set to b5-13, PID feedback
loss will be detected.
Default
∶
0%
Min.: 0%
Max.: 100%
b5-13 PID Feedback Low
Detection Time
Sets the PID feedback time used for detection.
When the PID feedback falls below the level set
to b5-12 for longer than this time, PID feedback
loss will be detected.
Default
∶
1.0 s
Min.: 0.0 s
Max.: 25.5 s
b5-14 PID Sleep Start
Level
Sets the PID level to trigger the controller to
sleep.
Default
∶
0.0Hz
Min.: 0.0 Hz
Max.:<5>
b5-15 PID Sleep Delay
Time
Sets the delay time used to activate/deactivate
the PID Sleep function. When this parameter is
set to 0.0, PID Sleep function will be stopped.
Default
∶
0.0 s
Min.: 0.0 s
Max.: 25.5 s
b5-16 PID Command
Acc./Dec. Time
Sets the PID command acceleration
/deceleration time used for PID target soft-start
function.
Default
∶
0.0 s
Min.: 0.0 s
Max.: 200.0 s
b5-17 PID Target
Selection
0
∶
PID Target Disabled
1
∶
PID Target Enabled
Default
∶
0
Range: 0, 1
b5-18 PID Target Value Sets the PID target value as a percentage of the
maximum output frequency when b5-17=1 and
Default
∶
0.00%
Min.: 0.00%