Cybernetics miSAN-V6, Operator'S Manual

Page: 105 / 190

105 Telnet Menu System
Cybernetics UM-MV-86-B1-0801
Chapter 4
Telnet Menu System
Telnet Menu System
This section describes the telnet menu system available used for configuration and oper-
ation of the miSAN-V-Series.
To use the telnet menu system, the unit must be powered on and fully initialized. To con-
nect, open a standard telnet or terminal emulation program on a host system connected
to the local network. Point to the miSAN-V-Series Management LAN Ethernet interface
(“ETH0”) IP address (default is
192.168.1.1 ; see “Network Configuration” on page 60 )
and the standard telnet port 23 . The telnet client should be set to VT100 emulation, no
local echo, and 80 × 24 characters or more.
Telnet access must be made via the TCP/IP network connection. If the unit includes more
than one network interface, a telnet session may by opened on any of the interfaces.
Access via a serial port is not supported.
Only one telnet session at a time is supported. If a second telnet session is opened from
the same or another host, on any interface, only a blank screen will be displayed.
When the telnet session connects, it will immediately display the following screen:
Type the username
menu
and press
ENTER
. The username “menu” is required for access
to the menu system. This username cannot be changed. If a password has been set, the
miSAN-V-Series will prompt for the password. If a password has not been set (default is
no password), an initial screen will be displayed, similar to the following: