D160S-T420 Portable
Service Hose Crimper
10
LUBRICATION PROCEDURE
Photo # 1
Photo # 2
Photo # 3
Grease Point # 1
Place a thin layer of CrimpX oil (supplied with crimper)
or a high pressure molybdenum high pressure grease
on the surface of the cone base.
(as shown in photo # 1).
Grease Point # 2
Before sliding the standard pressure plate or the notched
pressure plate over the correct dies, place a thin layer
of CrimpX oil (supplied with crimper) or a high pressure
molybdenum high pressure grease on the entire area
that dies come in contact with (as shown in photo # 2).
If Dies are sticking in the surface of the cone base:
Continue to lubricate / grease as explained above in
addition to lubricating each die finger individually.
(as shown in photo # 3).
Note:
The die fingers must be lubricated at both positions
that come in contact with the pressure plate and
the cone base.
Note:
Lubrication is not required before each crimp.
Typical lubrication is after 100 crimps.
Notched Pressure Plate:
For use with 90 degree fitting only.
