Custom Audio Electronics KPM180H, User Manual

Page: 76 / 152

6.6 Communication parameters
The parameters marked with the symbol D are the default values.
Settings remain active even after the device has been turned of and they are stored in non-volatile memory.
WIRELESS
Activation of wireless communication:
Of
D
On
The parameter is printed on setup report and has efect on device coniguration only for
TK180 MET, TK180 MET PRES, TK180 MET PRES UHF, TK180 MET UHF
RS232 BAUD RATE
Communication speed of the serial interface.
115200 D 9600
57600 4800
38400 2400
19200
This parameter is valid only with serial interface.
RS232 DATA LENGTH
Number of bit used for characters encoding.
7 bits/car
8 bits/car
D
This parameter is valid only with serial interface.
RS232 PARITY Bit for the parity control of the serial interface.
None D = parity bit omitted
Even = even value for parity bit
Odd
= odd value for parity bit
This parameter is valid only with serial interface.
RS232 HANDSHAKING Handshaking.
XON/XOFF = software handshaking
Hardware
D = hardware handshaking (CTS/RTS)
This parameter is valid only with serial interface.
When the receive bufer is full, if handshaking is set to XON/XOFF, the device sends
the XOFF (0x13) on the serial port. When the receive bufer has cleared once again, if
handshaking is set to XON/XOFF, the device sends the XON (0x11) on the serial port.
BUSY CONDITION Activation mode for busy signal:
Oline/RXFull = busy signal is activated when the device is both in Oline status and
the bufer is full
RXFull D
= busy signal is activated when the bufer is full
This parameter is valid only with serial interface.
76