![background image](http://html1.mh-extra.com/html/curtis/expr10/expr10_user-manual_2699632008.webp)
INSTALLATION INSTRUCTIONS
II22
Connect the Power Cable - 120 Volt Units
12 Connect the power cord to the appropriate type of
electrical outlet.
Power Up the Unit
13 Turn on the water supply valve.
14 Make sure that the circuit breaker supplying power to
the dispenser is on.
15 Turn the toggle switch on the back of the dispenser to
UIF0/QPTJUJPO5IFXBUFSUBOLXJMMTUBSUUPmMM8IJMF
UIFUBOLJTmMMJOHJOTQFDUUIFXBUFSTVQQMZMJOFGPSMFBLT
16
8IFOUIFXBUFSMFWFMJOUIFUBOLSJTFTUPUIF
correct volume, the heating element(s) will turn on
automatically. Depending on the incoming water
UFNQFSBUVSFBOEUIFFMFDUSJDBMTQFDJmDBUJPOTUIFXBUFS
tank typically requires 1 hour to reach the factory set
PQFSBUJOHUFNQFSBUVSF8IFOUIFXBUFSIBTIFBUFE
“Ready to Dispense” should be on the display.
17 If the unit is equipped with a hot water faucet, before
VTJOHUIFVOJUGPSUIFmSTUUJNFEJTQFOTFPVODFTPG
hot water from the hot water faucet to help purge air
from the tubing inside the unit.
18 Dispense at least 12 ounces from each spout, to purge
any remaining air from the tubing. See
OPERATING
INSTRUCTIONS
. During initial dispensing, and
XIFOFWFSUIFmMUFSJTSFQMBDFEZPVNBZIFBSUIF
TPVOETPGBJSCFJOHQVSHFEGSPNUIFmMUFSUVCJOHBOE
water tank.
WARNING:
Connect the power cord to the
appropriate type and size electrical outlet. If the
electrical outlet is not compatible with the power
cord, have it upgraded by a licensed electrician.
Do not modify the power plug. Do not use an
extension cord. Do not use a power cord/plug that
is damaged.
1$(5&913*/45"--"5*0/*/4536$5*0/4ø
100318A