PAGE 1 OF 20
0122 IH-1036
H-1036
ELECTRONIC KRAFT
TAPE DISPENSER
1-800-295-5510
uline.com
π
Para Español, vea páginas 7-13.
Pour le français, consulter les pages 14-20.
SAFETY
TECHNICAL DATA
IMPORTANT!
Read these instructions thoroughly and
familiarize yourself with all controls and
operating features. Keep for future reference
and maintenance.
Unpacking: Check the machine for damage. If
damage is found, return to Uline.
CAUTION! Only trained personnel should be
allowed to operate or service this machine.
WARNING! Burn Danger – Switch off power,
unplug the dispenser and allow the top heater
to cool down before performing any cleaning,
maintenance or repair.
Follow all safety and operating instructions contained in
this manual. Check state and local safety and
electrical codes.
NOTE: Tape dispenser is for use with gummed
tape ONLY. Uline accepts no responsibility for
damage due to improper use.
Check Voltage – Verify that machine voltage and power
supply voltage are the same before plugging in
the dispenser.
Keep the machine clean, dry and in good operating
condition. Do not place or operate machine in damp or
humid environments.
Overall Dimensions
17¾ x 11½ x 9¾"
Weight of Machine
26½ lbs.
Voltage and Frequency
See Machine Label
Control Circuit in DC
115 Volts
Electrical Power
100W
Dispensing Velocity
2.5 ft. or 30" / sec.
Length
Min. 4" / Max. 46"
Sound Measured in a Room
> 70 dB (A)
TAPE
Types of gummed tape: All
PAPER FEATURES
Width: min. 3/4" / max. 4"
Maximum roll diameter: 7¾"
