Curtis DYNA-FOG DYNA-JET L30 2 Series, Installation, Operation And Maintenance Manual

Page: 23 / 51

Connecting the Dyna-Jet L30 to the Vehicle Electrical System
Refer to the Vehicle Installation Kit Instruction Sheet for detailed
installation instructions.
Securely mount the 60 amp circuit breaker using the (2) Hex Bolts, Washers and Lock
Nuts provided.
IMPORTANT
To avoid damage to the machine and vehicle, ensure that the battery on the SPRAYER
has been fully charged before attaching to vehicle battery.
WARNING
The circuit breaker carries high current. Do not allow any conductive material (metal,
etc-) to contact the bare wires or connection terminals. Doing so can cause a short
circuit and produce sparks that could lead to a fire or explosion resulting in serious
injury or death! Ensure that rubber terminal caps are securely in place after connecting
cables! Do not mount the circuit breaker outside of the vehicle. The breaker should be
mounted in the engine compartment using the hardware provided, in a suitable location
near the vehicle battery. The fender-well is usually ideal, and has the advantage of
being an insulator (if it is plastic) to reduce the likelihood of shorting the ring terminals
on the breaker which will have positive electrical potential.
PART NO. QTY DESCRIPTION
120214 2 Washer, lock, 5/16 split
120382 4 Washer, lock, 3/8 split
120392 4 Washer, flat, ¼, reg.
121900 2 Bolt, ¼-20 x 1, hex
65167 2 Adaptor, battery post (GM reg)
65168 2 Adaptor, battery post (GM)
65169 2 Adaptor, battery post (Ford)
65171 1 Breaker, hi-amp
65176-2 3 Terminal, ring, 6g, ¼
65176-3 4 Terminal, ring, 6g, 3/8
65176-4 4 Terminal, ring, 6g, 5/16
65305 4 Nut, jam, brass 3/8-16
65306 2 Nut, jam, brass 5/16-16
9419454 2 Nut, nylock ¼-20
RM65188 Cable, 6g, black (300 inches)
RM65189 Cable, 6g, red (300 inches)
23