p. 6 of 12
7.
WINDSHIELD SUPPORT
7.1 See fig. 7.1. With assistance, install the windshield
support to the top front corner of the side frames oriented
as shown with the bent flanges on the bottom. In the low-
er holes only, use the following hardware per side frame:
one 5/16
-
18 x
1”
long button head bolt, two steel wash-
ers, one nylon washer, and one locknut. Refer to the
helpful hints section on page two for the proper place-
ment of the nylon washer. Do not tighten bolts. Note: the
upper hole on each side will get hardware once the roof
is installed.
8.
WINDSHIELD
8.1
See fig. 8.1. Have the following items ready: four
5/16
-
18 x
1
-
3/4”
long flat head bolts, four steel washers,
four locknuts, and two plastic spacer blocks. With assis-
tance, install the windshield hinges to the windshield
support with the two spacer blocks between the hinge
and the windshield support. Attach windshield latches to
windshield latch receivers on the cowl by squeezing tabs
to retract spring loaded pins. See fig. 8.1.1. Lift up on
bottom of windshield and close latches. Check alignment
of windshield with side frames and tighten hinge hard-
ware.
CAUTION: hinges are plastic components. Do
not overtighten hardware. Torque to 7 foot
-
pounds
maximum.
Also tighten both lower windshield support
bolts (from step 7 above).
Fig. 7.1 (view from front left side of tractor)
install
bolt
here
leave empty for now
Fig. 8.1 (view from front right side of tractor)
3/4”
thick spacer block
Fig. 8.1.1 (view from center of tractor)
latch
receiver