p. 7 of 12
middle
side bolt
Fig. 9.3 (view from front left side of tractor)
rear corner bolt
ref.: reflectors are back here
Fig. 10.2.1 (view from left side of tractor)
heads of
bolts up top
9.
ROOF
9.1
Use a Phillips head screwdriver to punch a hole
through the headliner at any of the covered bolt hole lo-
cations (8 places). Punch holes from the inside out to
avoid having the headliner pull away from its glued sur-
face.
9.2
Install the roof oriented so the reflectors are to-
wards the rear of the vehicle. Use the following hardware
in the two front corners: one 5/16
-
18 x
1”
long button
head bolt, two steel washers, one nylon washer, and one
locknut (locknuts on the inside surface). Install the bolt
through the roof, windshield support, and mounting tab.
See the helpful hints section on page two for placement
of nylon washers.
9.3
See fig. 9.3. The middle side and rear corner bolt
location on both the left and right sides uses the follow-
ing hardware per side: two 5/16
-
18 x
3/4”
long button
head bolts, two steel washers, and two nylon washers.
These bolts are installed into factory installed threaded
inserts in the top of each side frame.
NOTE
: use caution
to avoid damaging the internal threads on the factory
installed threaded inserts.
9.4
The remaining two holes in the middle front use the
following hardware: two 5/16
-
18 x
3/4”
long button head
bolts, four steel washers, two nylon washers, and two
locknuts. Locknuts to be on the inside surface.
10. TIGHTEN ALL BOLTS
10.1 Tighten all bolts at this time including the carriage
bolts on the roll bar brackets, etc.. Note: the roll bar
brackets should end up parallel and/or perpendicular to
the R.O.P.S. tubing.
10.2 Per figures 10.2 and 10.2.1, use the two holes in
the side frame floorboard as a guide to drill
3/8”
diameter
holes through the floor of the tractor.
WARNING:
check underneath for obstructions before drilling.
With assistance, depress the inner
-
most brake pedal to
gain clearance for the drill to be vertical when drilling
the front right bolt hole. Install the following hardware
per side: two 5/16
-
18 x
1”
long button head bolts, four
steel washers, and two locknuts. Locknuts to be under-
neath the tractor. Tighten these bolts.
Fig. 10.2 (view from seat of tractor)
drill a
3/8”
hole