p. 5 of 12
6.
SIDE FRAME (cont
’
d.)
6.2 Per fig. 6.2, use the following hardware installed
horizontally into the front of the side frame tubing (into
factory installed threaded inserts): three 5/16
-
18 x
3/4”
long button head bolts, three nylon washers, and three
steel washers. See helpful hint
“
D
”
on page 2 for proper
placement of nylon/plastic washers.
Use caution
to avoid
damaging the factory installed threaded inserts. Begin the
bolt engagement by hand to avoid or correct potential
cross
-
threading. Do not tighten bolts.
6.3 Per fig. 6.3, clamp the top corner of the cowl to the
side frame to assist in lining up the holes for the vertical
bolt. Use the following hardware in this location: one
5/16
-
18 x
3/4”
long button head bolt, two steel washers,
and one locknut. The head of the bolt is to be up top as
shown. Tighten bolt and remove clamp.
6.4 Per fig. 6.4, attach the back side of the side frame to
the roll bar bracket assembly. Note: fig. 6.4 shows an
optional hard rear panel in place. Use the following hard-
ware in each of the four roll bar bracket assemblies: one
5/16
-
18 x
1”
long button head bolt, one nylon washer,
and one steel washer. Thread into the factory installed
threaded inserts in the rear of the side frame tubing. Do
not tighten bolts.
6.5 For the remaining two threaded inserts per side
(one up top and one down bottom) on the back of the side
frame, leave them open if not installing a hard rear panel.
If installing a hard rear panel, use the following hardware
per side: two 5/16
-
18 x
3/4”
long button head bolts, two
nylon washers, and two steel washers. Thread into the
factory installed threaded inserts in the rear of the side
frame tubing. Do not tighten bolts.
6.6 Repeat all of section 6 for the opposite side frame.
6.7 Per fig. 6.7, new decals can be obtained from
Kubota and repositioned on the tractor if required.
Fig. 6.3 (view from front right side of tractor)
clamp here
head of vertical bolt
Fig. 6.4 (view from rear left side of tractor)
hard rear
panel
nylon washer, steel
washer, head of bolt
Fig. 6.7 (view from center of tractor)
Fig. 6.2 (view from front left side of tractor)
install
bolts
here