111 HIGGINS STREET, WORCESTER, MA 01606
MODEL: JOHN DEERE 2305, 2210 HARD SIDE & SOFT SIDE CABS
CABS/BLADES/ SPREADERS/ACCESSORIES
5. HARD SIDED REAR PANEL
(Optional on soft sided cabs)
5.1 (See Figure 9)
Tilt the tractor seat forward and have an assistant
help pass the rear panel through the front of the cab and position the
bottom of the panel against the base of the rear legs. Pivot the panel
up and into position against the rear legs being careful not to tear or
pull off the rubber gasket at the bottom of the panel.
5.2
Bolt the rear panel to the rear legs with four 5/16” X 3/4” button
head screws in the bottom four holes only. The top holes will be
used when bolting the roof on.
6. WINDSHIELD SUPPORT
6.1 (See Figure 10)
Install the windshield support to the side frames
with the bent flange down. Install only the bottom two 5/16 x 1”
long button head screws.
NOTE:
The top holes will get fasteners
once the roof is installed.
Align the edges of the windshield support
with the outside edges of the side frames and tighten bolts.
7. WINDSHIELD
7.1 (See Figure 11)
With assistance, install the windshield to the wind-
shield support. Use four 5/16 x 1 3/4” long flat head screws and two
3/4” thick plastic spacer blocks placed between the plastic hinge and
the windshield support.
7.2 (See Figure 12)
To install windshield bottom latches into the cowl
brackets, open windshield slightly. Grasp and squeeze the spring-
loaded tabs and cradle latches into cowl brackets, aligning tab boss-
es with their respective mounting holes.
7.3
To close, grasp the windshield bottom edge and lift slightly while
pushing closed. Fully close latches. Align sides of windshield with
side frames and tighten hinges. HINGES ARE PLASTIC COMPO-
NENTS. DO NOT OVER TIGHTEN. TORQUE TO 7 FT./LBS.
MAX.
FIGURE 9
FIGURE 12
FIGURE 11
FIGURE 10
p. 5 of 8
