111 HIGGINS STREET, WORCESTER, MA 01606
MODEL: JOHN DEERE 2305, 2210 HARD SIDE & SOFT SIDE CABS
CABS/BLADES/ SPREADERS/ACCESSORIES
3. SIDE FRAMES
3.1
With assistance,
remove doors from side frames (for easier han-
dling) by unlatching and sliding up and off the hinge pins.
3.2
(
See Figure 5)
Assemble left and right rear legs to the left and right
side frames with 5/16” X 3/4” button head screws in all but the top
holes. Cut the remaining piece of 1” flat bulb from the hardware kit
in half. Install along the bottom edge of the rear leg and along the
contour of the frame. Do not trim rubber at this time.
3.3 (See Figure 6)
Install the left side frame onto the tractor by in-
stalling the bolts and seat belt holder removed in step 1.2 through
the base of the rear leg. Attach to floorboard with 5/16” X 1-3/4”
long carriage bolts from hardware kit.
3.4 (See Figure 6)
Trim the 1” flat bulb at the bottom of the contour
even with the bottom of the tractor floorboard.
3.5
Repeat for right side frame.
3.6 (See Figure 7)
Check that 1” flat bulb on the front cowl assembly is
still pointing forward and attach the cowl assembly to left and right
side frames with 5/16” X 3/4” button head screws.
4. ROLL BAR BRACKETS
4.1 (See figure 8)
Install roll bar bracket mounts to left and right rear
legs with 5/16” X 3/4” carriage bolts.
4.2 (See figure 8)
Install roll bar brackets to the mounts with 5/16” X 1”
carriage bolts. NOTE: Carriage bolt heads should be on the bracket
side pointing toward the center of the tractor.
FIGURE 5
FIGURE 8
Right side viewed from
operators seat.
FIGURE 7
FIGURE 6
p. 4 of 8
