DESIGN CONCEPT
Curtis Cabs feature an assembly of parts designed for your vehicle which require
adjustment and alignment of components to accommodate vehicle variations and
provide proper weather protection. For accurate installation, proper operation, and
years of satisfaction, please read and understand the installation instructions.
From all of us at Curtis, we thank you for choosing our product.
CAB INSTALLATION
BEFORE YOU START
HELPFUL REMINDERS:
A. Leave all bolts loose for later adjustment unless otherwise specified.
B. Read and understand all instructions before beginning.
C. Plastic washers have been supplied to provide a weather seal around
all button head exterior fasteners. The plastic washer should be installed
under each bolt head directly against the outside cab surface. Care
should be taken not to over tighten the fasteners and damage the plastic
washer. Also use metal washers as required.
D. Apply a clear silicone sealant to seal any minor gaps that may occur due
to vehicle variances. E.G. front legs to bottom of unitized frames.
TOOLS REQUIRED:
This Curtis Cab is designed and manu-
factured for use only as reasonable
weather protection. This cab is not applicable, nor should
the cab be considered as protection against roll over,
collision or other accidents that may result. This cabs is
NOT
a
R.O.P.S.
cab.
Extreme
care should be taken when
operating and by qualified, experienced operators only
.
Exposure
to
Carbon
Monoxide
can
Cause
illness,
serious
injury
or
death.
Never operate vehicle if suspicious of Carbon Monoxide.
Inspect exhaust system for leaks monthly. Leaks can result
from loose connections, corrosion, cracks or other damage
to the exhaust manifold. If leaks are found, repair or replace
exhaust system. Do not use vehicle until repair or replace-
ment is complete.
driver and passenger.
Curtis accessory weights are listed in product
add additional weight to the base vehicle. All
Curtis Cabs, blades and general accessories
ADDED
WEIGHT
brochures. Deduct the accessory's total weight
from the vehicle's rated capacity and never
exceed the vehicle's rated capacity including
7/16 IN.
OPEN END
WRENCH
1/2 IN.
OPEN END
WRENCH
7/16 IN.
3/8 DRIVE
SOCKET
1/2 IN.
3/8 DRIVE
DEEP
SOCKET
3/8 DRIVE
RATCHET
NO. 2 MEDIUM
PHILLIPS HEAD
SCREWDRIVER
p. 2 of 8
3/16 INCH
ALLEN
DRIVE
3/8 DRIVE
12 mm
3/8 DRIVE
SOCKET
18 mm.
3/8 DRIVE
SOCKET
13 mm
3/8 DRIVE
SOCKET
13 mm
OPEN END
WRENCH
SNIPS