111 HIGGINS STREET, WORCESTER, MA 01606
MODEL: JOHN DEERE 2305, 2210 HARD SIDE & SOFT SIDE CABS
CABS/BLADES/ SPREADERS/ACCESSORIES
NOTE:
This cab is designed to fit the 2210 and 2305 tractors
with 210, 200X or 200CX loaders. It may or may not fit with oth-
er attachments or aftermarket loaders.
1. VEHICLE PREP
1.1
Remove SMV sign and bracket. On 2305 models r-install the turn
signal light with the hardware removed with the SMV bracket.
1.2 (See figure 1)
Remove and discard bolts from the tractor floorboard
as shown. There are 2 bolts on the left side but only one on the right
side.
1.3
(See Figure 1)
Remove seat belt holder bracket and the bolt next to
it from the base of the roll bar on both sides of the tractor. Retain for
later use.
1.4
(See Figure 2)
The plastic floorboard of the tractor must be leveled
before installing the cab. If the tractor is parked on a flat floor meas-
ure from the ground to the top of the floor board just in front of the
rear fenders. If no level surface is available block a straight edge up
against the bottom of the tractor frame and measure from it to the
top of the floorboard. If the right side is lower than the left have an
assistant lift up the right side of the floorboard and stack fender
washers from the hardware kit between it and the mounting bracket
where the bolt was removed in Step 1.2. Add washers to make the
measurement the same as the left side.
2. FRONT COWL ASSEMBLY
2.1 (See Figure 3) NOTE: Part descriptions can be found on pages 7
and 8.
Assemble the left and right front legs to the cowl with a 5/16”
X 3/4” long button head screw at the inside holes only. Assemble so
that the cowl is on the outside of the front legs.
NOTE: Use a nylon
washer in addition to the steel washers on all exterior button head
bolts as explained in helpful reminders on the previous page.
Align
the outer edges and tighten the bolts.
2.2 (See Figure 3)
Install one of the pieces of 1” flat bulb from the
hardware kit along the inner sheet metal edges. Trim so that the bulb
ends even with the bulb already installed on the bottom of the legs.
2.3 (See Figure 4)
Place cowl assembly onto the tractor. The 1” flat
bulb should point forward.
NOTE: On 2305 models the cowl co-
vers the operation decal. It is highly recommended a new decal,
part # LVU14471, be purchased from John Deere. Install the
decal on the inside of the cowl above the old decal.
FIGURE 4
FIGURE 2
FIGURE 1
FIGURE 3
TRIM EVEN
BOLT
p. 3 of 8
