18
5. Set the Final Position- Full Open
Twist the E-Wand TWIST HANDLE in the
OPPOSITE direction [Fig. 4.8] to move
the slats back to the FULL OPEN position.
Press and hold the PROGRAMMING
BUTTON until the slats begin to move
[Fig. 4.9].
The slats will automatically move DOWN
and back to the FULL OPEN position to
verify that the positions have been set
properly and that you have completed
programming the slat positions.
Note: When twisting to the final position, if you move past the full open
position, do not twist the opposite way back to full open. Instead, restart
programming.
To get out of programming mode, power cycle the unit by
partially unscrewing and re-tightening the battery cap. You have successfully
power cycled when you hear a tune.
Figure 4.8; Twist
Blinds to Full
Open
Figure 4.9;
Push and Hold
Programming
Button
You have now completed setting the open and close limits on the
E-Wand. You are now ready to add the E-Wand onto a Zigbee Network,
if desired [Pg. 26].
