7
REMOVING THE BOTTLE
Press the trigger for a few seconds to allow the stain to soak
into the pad before starting to move back and forth. Press the
trigger when more stain is needed.
Apply to one plank at a time (whole length) for an even finish,
in the same direction as the grooves. Ensure the grooves are
properly covered, you may need to go over the grooves a few
times. Use the brush and pad to smooth out any excess stain.
Press the bottle release
button to release the bottle.
Lift the bottle out and replace
the lid for future use.
Press to
release
PowerPad Decking Stain will
be touch dry in 2-6 hours in
good drying conditions. When
applying subsequent coats,
allow to dry fully before
recoating.
Avoid heavy wear and tear for
a few days after application.
Apply 2-3 coats depending
on the colour and degree of
protection required.
Note: The final colour will
depend upon wood type,
previous treatment and the
number of coats applied.
USING THE
POWERPAD
Push fit the dispensing spout
onto the bottle and pour into
a suitable container.
Dispensing
spout
DECANTING FOR BRUSH APPLICATION
After use, remove the spout
and clean with water before
the stain dries.
Replace the lid for future use.
