8887119
1/6 HP Portable Submersible Sump Pump
V1.0
8
For technical questions call 1-800-665-8685
4.
Avoid running the pump for more than 10 minutes at a time.
5.
If the pump becomes air locked, shut the power off for approximately 1
minute then restart the pump. Repeat several times to clear the air
from the pump.
CARE & MAINTENANCE
WARNING! Do not dissassemble the pump. There are no serviceable
internal parts. Dissassembly may damage the pump and cause a leak or
electrical hazard.
1.
Maintain the tool with care. A tool in good condition is efficient, easier
to control and will have fewer problems.
2. Make certain that the power source conforms to the requirements of
your equipment.
3.
Always disconnect the pump from the power source prior to repairs.
Always reconnect the pump to the power source after the repairs.
4.
Only use accessories intended for use with this tool.
5.
Maintain the tool’s labels and name plates. These carry important
information. If unreadable or missing, contact Princess Auto Ltd. for
replacements.
WARNING! Only qualified service personnel should repair the tool. An
improperly repaired tool may present a hazard to the user and/or others.
CLEANING
Rinse with clean water. Remove stubborn contamination with a brush and
detergent. Submerge the pump in a container with clean water and switch
on for a short time to rinse the inside of the pump.
CLEANING THE SUCTION AREA
Clean all accessible insides of the casing. Remove fibers that have wound
around the rotor shaft by opening the pressure connection. Remove
stubborn contamination with a brush and detergent.
NOTE! Before using the pump again, first soak the pump so that any possible
dirt residues do not block the appliance.
MAINTENANCE SCHEDULE
BEFORE EACH USE
Perform a visual inspection of the pump casing and cables for damage.
