V1.0
1/6 HP Portable Submersible Sump Pump
8887119
Visit www.princessauto.com for more information
7
IDENTIFICATION KEY
A
Discharge Outlet
B
Pump Casing
C
Inlet
ASSEMBLY & INSTALLATION
When this manual refers to a part number, it refers to
the included Parts Identification section.
HOSE CONNECTION
Use a suitable 5/8 in. water hose with the pump. When using a hose, screw
a suitable hose adapter onto the pressure connection. Push the hose firmly
onto the hose adapter and secure with a hose clamp.
LOCATION
1.
Make sure to locate the pump in a stable position.
2.
Make sure that the pump is located in a way that ensures the inlet
openings at the suction base are unobstructed. Place the pump on a brick
or cement, do not place the pump directly on open earth or gravel.
3.
Do not use the power cable to carry or hang the pump.
OPERATION
CAUTION! Do not operate the pump without a hose.
1.
Submerge the pump at an angle into the liquid to be pumped so that no air
pocket forms on the underside of the appliance. Suction would be prevented
by this air pocket. Once the pump is submerged, it can be righted again.
2. Leave the pump on the bottom of the liquid source.
3.
After the pump has been connected to the main power supply, the
pump will begin operating.
OPERATING TIPS
1.
Dry-running operation causes increased wear and is to be avoided. The
pump must be immediately switched off when water fails to flow.
2. After having pumped chlorinated swimming pool water or other liquids
leaving residues, the pump should be rinsed with clean, clear water.
3.
Sand and other abrasive materials in the liquid cause increased wear
and reduce the pump’s output.
