4
20
CUES Inc.
,
WTR III User Manual | TX920
CUES Inc.
,
WTR III User Manual | TX920
21
www.cuesinc.com
,
www.cuesinc.com
,
SYSTEM SET-UP & INSTALLATION
NOTE: For 18” - 24” configurations, a combination of adapters and spacers are required. Refer
to the Configuration Matrix in this manual for additional information.
The adaptation of the transporter to different pipe sizes is accomplished by changing the tires.
The WTR III incorporates the new
quick-change
wheel assemblies that are designed for
maximum efficiency and ease-of-use.
To Remove the Tires:
1. For 6” - 8” rubber and steel wheel assemblies, loosen the large center captive screw using
a 3/16th hex bit wrench.
For 10” and larger wheel assemblies, loosen and remove the large center screw using a
1/4” hex bit wrench.
2. Separate the wheel assembly and spacer, if applicable, from the shaft.
To Mount the Tires:
3. Select the appropriate tire, spacer, and screw, if applicable, for the pipe size to be
inspected. Refer to the Configuration Matrix in this manual for more information.
4. a. For 8” and larger pipe configurations, install the spacer, ensuring that the tri-lobe
pocket on the spacer is aligned with the tri-lobe on the shaft. For 8” and larger
configurations, the wheel assembly tri-lobe pocket needs to align with the raised tri-
lobe on the spacer.
b. For 6” configurations, align the wheel assembly tri-lobe pocket with the tri-lobe on
the shaft.
5. Hold the wheel and spacer against the WTR III shaft and secure the appropriate screw
using a torque wrench.
Refer to the
Configuration Matrix
for the proper
configuration for each pipe size to be inspected!
ADAPTING THE WTR III TO DIFFERENT PIPE CONFIGURATIONS -
WHEELS
