Cuckoo CRP-HU10 Tool Series, Operating Instructions Manual

Page: 11 / 60

hoW To cLeAn
11
w
w
w
.cu
ck
oo
w
orl
d.c
om
E
N
G
L
IS
H
2. To close the top cover, place the handle
in the “Unlock” position as shown in the
picture on the right.
1. Check to see if the inner pot is correctly
placed inside the main body.
3. If there are hot foods in the inner pot,
the top cover might not lock properly.
In this case twist the pressure weight
and allow the steam to release then
try to lock the handle.
Do not try to close the top cover by force. It can cause problems.
Cautions when top cover does not close perfectly
Inner Pot Inner Pot Lid Pressure Packing
Steam Vent Inner Body Moisture dish of the main body
If there are foreign substances stuck on the
temperature sensor, remove them without
damaging the metal plate. Cleanly wipe the
foreign substances or any moisture on the
heat plate. This part is designed to gather the
moisture coming through the steam vent
during cooking. Once cooking finished,
wipe it clean with a well wrung dish cloth.
Keep clean the Steam Vent before and after use.
While cleaning, make sure the pressure packing is
well in place. Clean it by wiping it gently. If the
pressure packing partially hangs off, press the part
that is hanging back into its original position with
your fingers.
Wipe any water on the Inner pot lid with a well
wrung dish cloth. Clean the Inner Pot with care
as it has a metallic edge.
Wipe the water on the outside and bottom of the
Inner Pot. A rough sponge, a brush or an abrasive
can cause scratches on the coating. Use a
dishwashing liquid and a soft cloth or a sponge.
※
Keeping the contact area of the Inner Pot with
the pressure packing always clean, increases
the product’s durability.
How to use handle
1. Handle must be located at “Lock” during Cooking.
The lamp turning on means the top cover is closed perfectly, so you can cook.
2. After cooking, the handle must be turned from
“Lock” to “Unlock”, and then push clamp knob to open.
It is hard to open when there is remaining steam in the Inner pot. At the time,
twist pressure weight and let the steam out. Do not open by force.
3. Handle must be located at “Unlock” when open and close.
•
If the lamp does not turn on, it would not operate
“Cook” and “Preset” buttons. Make sure the
handle is located at “Lock”.