CTC Union GSW-3420FM, User Manual

Page: 15 / 145

command under “(config)#”. Users with different previlege levels will have
different access rights for functions of the switch. Please refer to Privilege Level
Configuration of the switch.
[ command line level ]
After login the switch, a prompt “ # ” will be shown. Because this switch supports
command-line for console interface, you can press “ ? ” to check the command
list.
With “
? ” command, you can find the command list as follow.
---------------------------------------------------------------------------------------------
# ?
clear Reset functions
configure Enter configuration mode
copy Copy from source to destination
delete Delete one file in flash: file system
dir Directory of all files in flash: file system
disable Turn off privileged commands
do To run exec commands in config mode
dot1x IEEE Standard for port-based Network Access Control
enable Turn on privileged commands
exit Exit from EXEC mode
firmware Firmware upgrade/swap
help Description of the interactive help system
logout Exit from EXEC mode
more Display file
no Negate a command or set its defaults
ping Send ICMP echo messages
reload Reload system.
send Send a message to other tty lines
show Show running system information
terminal Set terminal line parameters
#
---------------------------------------------------------------------------------------------
These are the basic system commands for the switch.
For system configuring, “ configure terminal ” command can enter the configure
mode. And the prompt will become ...
----------------------------------------------------------------
# configure
(config)#
----------------------------------------------------------------
In the configure mode, the general configuration of switch can be done. And
“exit” command can leave this mode.
If settings for port, “ interface ” command is used. And the prompt will
become ...
----------------------------------------------------------------
(config)# interface GigabitEthernet 1/5
(config-if)#
----------------------------------------------------------------
“
GigabitEthernet 1/5
” means Gigabit Ethernet interface 1, port 5. And “exit”
12