CTC Union GSW-3208M1, User Manual

Page: 73 / 240

70
6.2.4 Interface Configuring Commands
Commands in Configuring Mode are for general switch settings. And its
prompt is “(config)#”.
The port interface function and VLAN group interface function are set with
“interface” command.
(config)# interface ?
ethernet Ethernet port
vlan Sw itch Virtual LAN interface
interface ethernet 1/x
command is used to configure settings for
Port x
.
Please refer to section
6.2.4.1 Interface Configuring Commands for Port
for the details.
interface vlan x
command is used to configure
VLAN Group x
interface (“x” is
the VLAN ID). Please refer to section
6.2.4.2 Interface Configuring
Commands for VLAN
for the details.
Both commands will change the prompt from “(config)#” to “
(config-if)#
”.
Note: Th
e general VLAN settings are done with “
vlan database
” command.
Please refer to section
6.2.5 VLAN Configuring Commands
for the details.
And
interface vlan x
command is used to assign characteristics to a VLAN
interface. For example, assigning IP address to a VLAN interface is done with
this command.
6.2.4.1 Interface Configuring Commands for Port
Commands in Configuring Mode are for general switch settings. And its
prompt is “(config)#”.
If the settings are for ports, it is done with “
interface ethernet 1/x
” command in
configure mode. For example, “interface ethernet 1/5” is for settings on Port 5.
Some syntax are supported for port selection.
1.
interface ethernet 1/x
and “
x
” is port number. All the settings after this
command will be applied to thi
s port. For example, “interface ethernet 1/5”
and all the settings after this command will be applied to Port 5.
2.
interface ethernet 1/x,y,z,...
and “
x
”, “
y
”, “
z
",.. are port number. All the
settings after this command will be applied to these ports. For example,
“interface ethernet 1/2,4,7” and the settings after this command will be
applied to Port 2, Port 4, and Port 7.
3.
interface ethernet 1/x-y
and “
x
”,”
y
” are port number. All the settings after