CTC Union GSW-3208M1, User Manual

Page: 52 / 240

49
After MVR VLAN is created, you can assign IP multicast groups (video
channels) to the MVR VLAN. And you can assign more than one IP multicast
groups (video channels) to one MVR VLAN. For
example, “mvr 10 group abc
start-address 224.0.0.1 end-
address 224.0.0.2”.
mvr x mode [compatible | dynamic]
command is used to s pecify the MVR
mode of operation. In Dynamic mode, MVR allows dynamic MVR membership
reports on source ports. In Compatible mode, MVR membership reports are
forbidden on source ports.
“
x
” is the Multicast VLAN ID.
mvr x name yyy
command is used to create a name for Mltuicast VLAN.
“
x
”
is the Multicast VLAN ID. “
yyy
” is the name of the MVR VLAN. MVR Name is
an optional attribute to indicate the name of the specific MVR VLAN. Maximum
length of the MVR VLAN Name string is 32. MVR VLAN Name can only contain
alphabets or numbers. When the optional MVR VLAN name is given, it should
contain at least one alphabet.
mvr x priority y
command is used to specify how the traversed IGMP/MLD
control frames will be sent in prioritized manner. “
x
” is the Multicast VLAN ID.
“
y
” is the priority with value 0~7.
mvr x status-clear
command is used to clear MVR operational status and
statistics
for Mltuicast VLAN “x”. “
x
” is the Multicast VLAN ID.
mvr x tagging [tagged | untagged]
command is used to specify whether the
traversed IGMP/MLD control frames will be sent as Untagged or Tagged with
MVR VID. “
x
” is the Multicast VLAN ID.
mvr x name yyy
command is used to create a MVR VLAN with VLAN ID “
x
”
name “
yyy
”. “
no mvr x
” command is used to delete a MVR VLAN. “
x
” is the
Multicast VLAN ID.
After MVR VLAN is created, source port of IP multicast traffic and receiver ports
of subscribers will be assigned next. Assigning source port and receiver port
to MVR VLAN is done in “(config-if)#” mode (go with “interface ethernet 1/x”
command. “x” is the port number.) Please refer to “mvr” command in
Section 6.2.4.1 for the details.
27
no
command
This command is used to disable a function or restore a setting to factory
default of the switch.
(config)# no ?
aaa AAA Service
aggregation Set aggregation mode configuration
arp-inspection Set ARP inspection configuration
dhcp-relay Configures DHCP Relay Configuration
dhcp-snooping Configures DHCP Snooping Configuration
dot1x Configures 802.1x port-based access control