CTC Union GSW-3208M1, User Manual

Page: 39 / 240

36
Note:
1.
Setting 802.1x function on ports, use “dot1x” command in interface
configuring mode.
2.
Setting for RADIUS servers, use “radius -accounting-server” and “radius -
authentication-
server” command.
Please refer to sections for the commands.
14
end
command
This command is used to exit from configure mode.
15
hostname
command
This command is used to set the name of the switch in network. This name
is also used as the hostname for SNMP agent function of the switch.
16
interface
command
This command is used to entering
interface configuring mode
. There are
two sub-commands for it -
one is “ethernet”, it is for port setting, another is
“vlan”, it is for VLAN groups characteristics setting.
(config)# interface ?
ethernet Ethernet port
vlan Sw itch Virtual LAN interface
All the port setting commands are put in interface configuring mode - like rate-
limit setting, speed-duplex setting, .... And characteristics settings for VLAN
groups are also done in interface configuring mode - like IP address
assignment.
For example, the console will enter interface configuring mode for Port 5 with
“interface ethernet 1/5” command. And the prompt will become ...
(config)# interface ethernet 1/5
(config-if)#
With “interface ethernet 1/5,6,10-13”, the console will enter interface
configuring mode for Port 5, 6, 10, 11, 12, 13. And all the settings will be
applied to those ports at the same time.
The description of com mands in interface configuring mode is put in Section
6.2.4 Interface Configuring Commands
. Please refer to the section for the
details.