Chapter 3. Operation
23
3.3 Operating Procedure
The
EOe-1
requires no operator attention once installed,
except for occasional monitoring of the front panel indicators.
Intervention is only required when:
•
The
EOe-1
has to be adapted to new operational
requirements.
•
Diagnostic loops are required.
The
EOe-1
is turned on when its AC power cord (or central
office DC power) is connected to an AC power outlet (or the DC
input connections) and the power switch is turned to the ON
position. The Power LED indicator will light, indicating that the
EOe-1
is on. Verify the
EOe-1
is in operation by checking that
the front panel LED's match the following indicator conditions:
•
Power:
ON
•
Signal
Loss: OFF
•
Alarm:
OFF
•
Link:
ON
•
TD:
ON, OFF or Flashing
•
RD:
ON, OFF or Flashing
•
100:
ON (for 100Base-TX)
•
Full:
ON (for Full Duplex Ethernet)
•
Error:
OFF
•
Error:
OFF
•
Test:
OFF
Summary of Contents for EOe-1
