Replacing the SDRAM
Chapter 4: Troubleshooting the PA PowerStation
62
PA PowerStation User Guide
6. To disconnect the ribbon, put your thumbs on the drawer tabs on
each side of the connector and slide the tabs out. In the above
picture, the tabs slide out to the right.
7. Remove the circuit board.
•
For the 5" and 6", remove 4 stand-offs on the board.
•
For the 8" and 10", remove 4 Phillips screws.
8. Lift the circuit board and turn it over to reveal the SDRAM. See the
following picture.
9. Push the ears out that hold the SDRAM in place.
10. With the bottom edge of the SDRAM still attached to the board, lift
the top edge of the SDRAM up to a 45 degree angle.
11. Slide it free.
12. Slide the new SDRAM into place at a 45 degree angle.
13. Press it down against the board, pushing the top edge of the
SDRAM until you hear the ears click into place.
SDRAM
Ribbon
connector
StockCheck.com