11
【
MODE
】
Select desired operating mode
–
CW/AM/LSB/USB.
Select CW for Morse Code, AM for amplitude modulation, LSB for lower side band when using
single sideband modulation, and USB for upper sideband when using single sideband modulation.
The modulation choice is shown on the second line about the middle of the screen.
【
AGC
】
Select AGC (Automatic Gain Control) level-FAST/SLOW/OFF
Use automatic gain control when you want to have the audio output at a constant level even when
the people speaking vary how loud or soft they are speaking. It is recommended to keep this feature
off when you have a very weak signal. The choice of fast or slow is dependent on the noise and type
of signal you are listening to. When the AGC is set to OFF, the S meter is disabled. The AGC choice is
shown below the frequency readout in the middle of the screen.
【
NB
】
Select NB (Noise Blanker) level between 1 and 4 and OFF
This feature is used to minimize hearing ignition type of noise. The NB indication is shown below the
frequency and to the left of the AGC indication.
【
A/B
】
Switch between VFO A & VFO B.
This feature allows you to quickly toggle between two discrete frequencies. It is very useful if you want to monitor
two separate conversions or possible monitor both the input and output frequencies of a repeater. The VFO
indication is shown on the second line of the display towards the left.
Summary of Contents for CS108G+
Page 30: ...www connectsystems com...