Crystal Vision
Trouble shooting
Indigo 4 User Manual R1.7
35
09/08/2012
Inserting a PSU
To insert a PSU proceed as follows:
Check that the power supply is the same type as already fitted.
Offer up the PSU to the frame guide rails – it may help to turn the lower PSU
handle fully outwards to clear the panel hinge
Carefully push the PSU all the way into its socket
Notes:
PSU modules should only fit into the PSU slots behind the PSU fan assembly. Do not
attempt to fit a PSU into a video or audio module slot.
Check that the two/one switch behind the control panel is set correctly for the number of
PSUs installed to prevent redundant PSU warnings.
Fitting the fan assembly
To refit the PSU fan assembly proceed as follows:
Offer up the fan assembly ensuring that the two lugs fit into two slots in the right
hand side of the frame just in front of a plastic stop
Carefully move the fan assembly into position ensuring that the two PSU fan
jacks fit into the PSU jack sockets (SK 1)
Take care not to damage the panel ribbon cable
Tighten the two captive screws to the left of the PSU fan ensuring that they are
not too tight to be undone without a screwdriver
If the unit was unpowered it may now be powered and tested
