Crystal Vision
Operating the Active Panel
Updating the display
The values displayed on an active front control panel are only updated when an adjustment is
made and when changing menu level. If changes occur through the use of card edge controls
or other remote control, the text displayed on the active front control panel will not be updated
immediately. If necessary, use the upward arrow to leave and then re-enter a menu to update
the display.
Slot numbers
In Indigo frames, the slot or location numbers are determined by the position of the card in the
frame.
The front panel PIC controller and PSUs are allocated slot numbers as follows:
Device
Address in
frame
Notes
Modules
1.01 to 1.06
Press ENTER for module Home menu
Indigo PIC
1.00
Press ENTER for frame s/n and temp
PSU
1.14
Press ENTER for PSU s/n and type
The Indigo PIC ‘1.00’ modules will display the air temperature, in degrees Celsius, inside the
frame above slot 3 where the temperature sensor is located.
Node numbers
Whilst most Crystal Vision cards have their unique card location address assigned
automatically, older cards and frames use a ‘node’ switch on each card.
In all of the current frames, this node switch should be set to zero (factory default).
For compatibility reasons, the Home menu for each module may display the module's node
number (one less than its location or slot number).
Please refer to the Appendix to find out how node numbers relate to slot numbers in particular
frames and frame combinations.
Further details of module operation can be found in the documentation supplied with
each module.
Indigo 1 User Manual R1.14
63
27 February 2020
