INSTALLATION STEPS
FITTING TRIMS
FIT THE TRIM WITH FOUR MAGNETS PLACED ON THE VERTICAL SIDE FLANGES OF THE FIREBOX
(ONE AT THE TOP AND ONE AT THE BOTTOM 0
OFFER THE BRASS TRIM UP AND PUSH INTO POSITION
PLACE FRET CENTALLY IN FRONT.
INSTRUCT USER
IMPORTANT : THIS APPLIANCE IS FITTED WITH AN OXYGEN DEPLETION SENSOR
INCORPORATED INTO THE PILOT BODY. SHOULD THE FIRE REPEATEDLY EXTINGUISH ITSELF
THEN SPECIALIST ADVICE SHOULD BE SOUGHT, AS THIS MAY INDICATE SPILLAGE INTO THE
ROOM OF COIMBUSTION PRODUCTS.
WARNING
THE OXYGEN DEPLETION SYSYTEM MUST NOT BE ADJUSTED BY INSTALLER
THE OXYGEN DEPLETION SYSTEM MUST NOT BE PUT OUT OF OPERATION
WHEN REPLACING OXYGEN DEPLETION SYSTEM ONLY ORIGINAL MANUFACTURERS PARTS SHOULD BE
USED
DEMONSTRATE THE LIGHTING AND EXTINGUISHING PROCEDURES TO THE USER AND REMOVAL
AND REFITTING OF THE BRASS TRIM FOR CLEANING.
THE APPLIANCE SHOULD BE OPERATED WITH THE GAS CONTROL NOT TURNED ON MORE THAN
LOW FOR THE FIRST FIVE HOURS OF USE TO ALLOW THE FIBRE COALS TO CURE SLOWLY.
THE CURING EFFECT OF HEATING THE COALS AND OTHER CERAMICS COMPONENTS WILL CAUSE
AN INITIAL ODOUR.
THE APPLIANCE SHOULD BE SERVICED ANNUALLY BY A COMPETENT PERSON IN ACCORDANCE
WITH THESE INSTRUCTIONS AND THE APPLIANCE CHECKED FOR SPILLAGE IN ACCORDANCE WITH
THE METHOD DETAILED IN THESE INSTRUCTIONS.
HAND THESE INSTRUCTIONS TO THE USER.
ISSUE 1
