Section 3
Fitting fuel bed and commissioning
3.1 assembling the fuel bed
PERIODICALLY SMALL DEPOSITS OF SOOT MAY GATHER ON THE FUEL BED AND
BURNER, THIS MUST BE REMOVED BY REMOVING FUEL AND BRUSHING ANY
DEPOSITS WITH A SOFT BRUSH AND VACUUMING THE BURNER, THEN REPLACE
FUEL USING THE FOLLOWING PROCEDURE.
THE MAIN FIBRE BASE IS LIABLE TO HAVE SURFACE CRACKS DUE TO THE HIGH
TEMPERATURES OF THE FIBRE AND THE PAINT BEING DIFFERENT THIS IS
QUITE NORMAL AND SHOULDN’T CAUSE CONCERN
Issue 1
!
11
The rear matrix sits flat behind the
two lugs
With the front fibre sitting in the well
of the burner
Front 4 coals sit as shown
Left hand coal sits with fatter end to
left
and as far left as possible
Right hand coal sits slightly left from
the far right
Allowing 2 central coals to sit in
middle
Next 3 sit central as shown
