5.3
MERTIK MAXITROL REMOTE CONTROL SYSTEM
THESE INSTRUCTIONS ARE FOR THE USE ON CRYSTAL FIRES REMOTE CONTROL
RANGE OF GAS FIRES
OPERATION
LIGHTING PROCEDURE
1. TURN KNOB
A
(FIGURE 1) SLIGHTLY LEFT TOWARDS THE IGNITION POSITION
(SHOWN IN FIG 1 ABOVE) UNTIL REACHING STOP,PRESS DOWN AND HOLD
FOR FIVE SECONDS
(ONLY PILOT GAS FLOWS)
2. CONTINUE PRESSING DOWN KNOB
A
WHILE TURNING FURTHER LEFT TO
ACTIVATE PIEZO,CONTINUE TO HOLD DOWN FOR 10 SECONDS AFTER PILOT
HAS BEEN LIT,IF PILOT DOES NOT LIGHT,STEPS 1 AND 2 CAN BE REPEATED
IMMEDIATELY.
3. UPON LIGHTING,RELEASE KNOB
A
AND TURN FURTHER LEFT TO ON
POSITION (SHOWN IN FIGURE 1 ABOVE)PILOT GAS FLOWS AND MAIN BURNER
FLOWS IN ACCORDANCE TO THE TEMPERATURE SETTING(KNOB
B
AS SHOWN
IN FIG 1 ABOVE)
ADJUSTING THE FLAME SETTINGS
TO TURN THE FIRE ON AND/OR TO ADJUST THE FLAME STTING, PRESS THE ON
BUTTONS ON THE REMOTE HANDSET.CONTINUE PRESSING UNTIL
DESIRED FLAME SETTING IS OBTAINED.PRESS AND HOLD THE OFF BUTTON TO
REVERSE THE SETTING.THE RECEIVER IS EQUIPPED WITH ABUILT IN DELAY,
RECOGNISABLE BY THE FLICKERING LIGHT,TO FACILITATE FINE ADJUSTMENT
OF THE FLAME
THE MOTORISED VALVE IS EQUIPPED WITH A SLIP CLUTCH ,ALLOWING
MANUAL ADJUSTMENT OF MAIN GAS BY TURNING KNOB B
Issue 1
!
19
On position
Off position
Ignition /pilot position
Fig 1
A
B
