9
9. INSTALLATION OF THE WOODEN SLATS (LS1- LS2- LS3- LS4)
Put the textile tape (C) around the steel wall and adjust it in order
for it to remain on the top of the pool (30 cm from the top approx.).
To tighten the tape, please follow these steps:
1
- Thread one end inside the two rings and tighten to adjust the belt to the wall.
2
-
Take the end of the tape and wipe inside the second ring as shown in the second image.
3
- Pull the end you just entered and finally adjust the tape to the band in order for it not to fall.
1
2
3
Don’t tighten the textile tape too much now as the steel wall could be deformed. It’s enough for
it to remain hold.
To place the wood slats is very simple. Separate the tape with a hand and introduce the slats
between the tape
and the wall, from top to bottom (fig.13), by sliding it until it snaps into the bottom guide wire
(fig.14)
Fig. 13
Fig.14
Summary of Contents for Barrica Series
Page 20: ...20...
