Crystal Enterprises Barrica Series, Assembly Instructions Manual

Page: 14 / 20

14
13. LAST DETAILS
Once all profiles and top connectors have been placed, you can cut the
excess of the liner (that overlaps out below the metal guides). Use a pair of
scissors or a blade to do it. Pull the end of the liner and cut it carefully, as
it’s shown in the picture (fig. 28).
Put “adhesive advices” in a visible place (i.e. close to the ladder). Figs. 29,
30.
fig. 29
fig. 30
- Assembly the ladder following the instructions and place the sticker it in a visible place, in the entry/exit way of
the pool. Remove it after using it.
- Assembly the filter equipment following the instructions of its manual. It must be placed (as min.) 3,5 meters far
from the pool, once plugged and connected to it by the hoses.
14. INSTALLING THE RETURN VALVE (VR)
The return valve is the item through which the water returns to the pool, after having been filtered in the filter
equipment (fig. 35).
Important : Put Teflon in all threads. The excess of Teflon can cause breaks of the pieces.
Remove the rear fitting of the return valve and put Teflon, then screw it until the end.
Fig.31
Fig. 36
Fig. 37
1) Once the water r/-10 cm under the bottom edge of the valve, mark a cross in the hole (in the liner)
with a felt pen. Cut with a blade, from the inside to the outside, very carefully and make the cross without
exceeding the hole. Place the rubber washer (B) on the steerable grid (A) and introduce it into the hole, inside the
pool (Fig. 36). From the inside to the outside, cut the piece of the liner that exceeds on the outside.
2) Place the rubber joint (C) out of the pool. Put Teflon on the threads and firmly tighten the nut (D) (fig. 37). Put
Teflon and insert the return hose (E), that runs from the from the outlet of the filter to the return valve (A), and
secure it with the clamp (H)
.
For the best filtration, we suggest you orientate the jet of water, so the washer/ring (AR). Move the
adjustable ball (BO) towards one of the sides of the pool and slightly down and then, fasten the ring (AR). In this
way, the impurities will be directed to the skimmer and the water will circulate throughout the pool.
fig. 28