Crown CT61001HX, Original Instructions Manual

Page: 27 / 160

27
English
Removal of deformed fasteners (see fig. 14-15)
Sometimes, during operation, the fastener 19 or 20
becomes deformed and remains inside the striking
mechanism (for example, when the fastener hits a
solid object, if the fastener is defective, etc�)�
• Remove the battery 5 from the power tool and
remove the remaining fasteners 19 or 20 from the
magazine 11 �
• Remove the plastic tip 14 (see fig. 14.1).
• Unscrew the bolts 13 using the Allen key 18 (see
fig. 14.2).
• Carefully remove plates 15 and 16 and remove the
deformed fastener 19 or 20 (see fig. 15). Caution: the
striking mechanism can be loaded to shot and if
you will try to remove the fastener out it will be
forcefully pushed out, possibly causing injury.
•
Reassemble in reverse order�
• If the deformation of fasteners 19 or 20 occurs
regularly (even when using fasteners from another
manufacturer) - contact the CROWN service center�
Cleaning of the power tool
An indispensable condition for a safe long-term exploi-
tation of the power tool is to keep it clean� Regularly
flush the power tool with compressed air thought the
ventilation slots
1
�
After-sales service and application service
Our after-sales service responds to your questions
concerning maintenance and repair of your product as
well as spare parts� Information about service centers,
parts diagrams and information about spare parts can
also be found under: www.crown-tools.com �
Transportation of the power tools
• Categorically not to drop any mechanical impact on
the packaging during transport�
• When unloading / loading is not allowed to use any
kind of technology that works on the principle of clamp-
ing packaging�
Li-Ion batteries
The contained Li-Ion batteries are subject to the Dan-
gerous Goods Legislation requirements� The user can
transport the batteries by road without further require-
ments�
When being transported by third parties (e�g�: air trans-
port or forwarding agency), special requirements on
packaging and labelling must be observed� For prepa-
ration of the item being shipped, consulting an expert
for hazardous material is required�
Dispatch batteries only when the housing is undam-
aged� Tape or mask off open contacts and pack up the
battery in such a manner that it cannot move around
in the packaging� Please also observe possibly more
detailed national regulations�
Environmental protection
Recycle raw materials instead of dispos-
ing as waste.
Power tool, accessories and packaging should
be sorted for environment-friendly recycling�
The plastic components are labelled for categorized
recycling�
These instructions are printed on recycled paper man-
ufactured without chlorine�
The manufacturer reserves the possibility to introduce changes.