Crosswave Elektrobike ED-3.2 EX, Operating Instructions Manual

Page: 82 / 144

BA_Migros_ED3EX_GB 25.02.2013 19:50 Uhr Seite 10
Schwarz
C M Y CM MY CY CMY K
Loading the Pedelec
– The permissible total load (rider and luggage) on the
CROSSWAVE Pedelec is 120kg.
– The permissible load of the luggage carrier is mentioned on
the luggage carrier.
– If your cycle is equipped with a front basket, the additional
load allowed here is 5kg.
Braking response
– Use the front wheel brake carefully on wet, sandy and slippery
roads, wet asphalt and ice, to keep the front wheel from
skidding and to retain the Pedelec under control!
– The brakes must be used with care. Blocked wheels have
a reduced braking effect and can lead to loss of balance
and fall!
– As a matter of principle, do not apply the brakes in curves
but before them; braking increases the risk of skidding!
– The braking lever mounted on the handle bar must always be
tight. Check regularly to ensure that they are not loose,
and tighten if necessary.
– Work on the brake system should be entrusted exclusively
to the dealer!
Proper use of the Pedelec:
Your Pedelec has been designed and equipped like a bicycle for
the use on public roads and paved lanes. Please bear this in
mind when using the Pedelec under off-road conditions and in
case of overloading and improper rectification of faults.
When? Servicing / check Action
After approximately
100 km and
subsequently at least
1x per annum Check the tightening torque
of screws, cranks, pedals,
handle bar, seat support and
seat. Adjustment of gear,
control set, spring elements
and brakes. Check the wheels
and tyres Customer Service,
Service Department
or specialized
workshop
After every ride Check the rims, spokes, tyres,
bell, brakes, quick release,
lights and the function of the
gear and springs Check the rims for
concentricity and
wear marks. Check
tyres for foreign
bodies
Regularly after
300–500 km Check the cranks, sprocket
wheel and pinion. Check
chain wear and tear, stability
of all screws, wear indication
on the rim Clean and apply
chain grease
After 1000 km Back pedal brake, VR-HR
hubs Dismantle, clean and
apply grease. Check
brake jacket, replace
if necessary
After 3000 km Control set, pedals, hubs,
brake and control wires*) Let Service check,
dismantle, clean,
lubricate and replace
if necessary
After rain Chain, wiring Clean, lubricate
* Do not oil Teflon coated cable jackets!
82