BA_Migros_GB_s1bis32 11.02.2009 12:49 Uhr Seite 6
Probedruck
6
4)
You can switch over to power saving mode by actuating
the ECO key at the right.
5)
Start pedalling. The motor is activated after a half-rotation
of the pedals.
6)
If you are riding the cycle for the first time, we request
you to try out the two drive modes well away from busy
roads.
7)
There are two drive modes – Normal and Eco. The motor
output is limited in the Eco mode. This increases the
mileage.
8)
At the end of the ride, switch the system off by pressing “O”.
9)
The CROSSWAVE Pedelec will take you home even on an
empty battery like an ordinary cycle.
The battery electronics
prevents an excessive discharge of the battery.
10)
Recharge the fully empty Lithium-ion battery after
completing the ride.
If the Lithium-ion battery is only
partially empty, continue to use it for subsequent rides till
the battery is
completely empty.
11) If you do not use the battery for more than 6 month,
recharge it fully.
Enjoy your drive on the CROSSWAVE Pedelec!
Quick start
Even though you might be eager to use your newly purchased
CROSSWAVE Pedelec immediately, we request you to observe
the following steps without fail before taking your first ride.
PanTerra™ will not accept any guarantee obligations otherwise!
1)
Remove all the protective foils from the battery. Please
check the current charging status of your battery by
pressing the key on the LED display (refer to Page 14). The
CROSSWAVE Pedelec is powered by a Lithium-ion battery.
If less than 2 LEDs light up or no LED lights up, it could
be possible that the battery is damaged. In this case,
please get in touch with your dealer! Do not try to
charge the battery! Do not ride!
Now charge the battery fully first! Please use the original
PanTerra™ Lithium-ion charging device only. Then insert
the battery in the luggage carrier holder and secure the
lock (refer to Page 17).
2)
Adjust the handle bar and seat; check to ensure that the
drive and brakes function and that all screws, especially
the wheel nuts are properly fixed (refer to Page 17).
3)
Switch the system on at the left of the handle bar: Press
the switch to “I” on the control unit. The CROSSWAVE
Pedelec is now ready for a ride.
The electronic circuit
however is deactivated after about 8 minutes of inactivity
in order to save energy!
If this happens, switch off and
then on again.
Operating instructions
