BA_Migros_GB_s1bis32 11.02.2009 12:49 Uhr Seite 30
Probedruck
30
Below you will find the two plug-in connectors for driving power
(big) and runner position control (small) (Figure 23). Memorize
the position of the cables under this cover; otherwise a wrong
position of the cables can later prevent the closing of the cover.
Refer to Section
“Assembly”.
The plug-in connector can be disconnected by unlocking the
safety hooks. If you press them, the plug-in connector can be
detached. Refer to Figure 24.
The plug-in connector for driving power (big) could be slightly
different in your bicycle. The round connectors are simply pulled
apart.
Dismantling the front wheel
If due to a tyre damage you have to dismantle the front wheel,
please proceed as follows:
Dismantling:
Open the cover on the axle nut (Figure 22) on the right side of
the fork.
It contains the detachable plug-in connection of all motor
cables. Loosen the two screws and apply mild pressure to pull
the plastic cover out.
Figure 22
Figure 23
Figure 24
Figure 25
Operating instructions
