BA_Migros_GB_s1bis32 11.02.2009 12:49 Uhr Seite 14
Probedruck
14
The compartment containing the battery fuse is located on the
side (cover with the imprint “Fuse”). If you do not want to use
your battery anymore, please pull this fuse out. The protective
electronic circuit of the battery will otherwise continue to draw
a small amount of power, quite unnecessarily.
Insert the drive battery in the CROSSWAVE Pedelec as illustrated
in Figures 3 and 4 into the tray. Ensure that the contact pins
of the motor electronics which is permanently fixed in the tray,
slide smoothly into the contact strip of the drive battery.
Check the charging status of the battery. To do this, press the
knob at the LED display on the top side of the battery. Refer to
Figure 2
If all the 5 LEDs do not light up, PanTerra™ recommends that
you first charge the battery fully.
To do this, connect the drive battery to the charging device
included in the scope of delivery. Refer to the Chapter
“Charging
the drive battery”
on Page 15.
Lithium-ion batteries get self-discharged much
slower than Nickel batteries and can therefore be
stored for approximately 6 months without
recharging. However, if the battery is not recharged
after this period, the chemical structure can be
damaged, which affects the performance of the
battery considerably and can make it unusable.
Figure 2
Figure 3
Figure 4
The drive battery should be kept flat in the tray as shown in
Figure 4.
Let the cylinder snap into place in the battery housing. The
locking ensures that the battery is held tightly to avoid damages
caused by jerks and vibrations. It also guarantees optimum
electrical contact of the battery with the electronic circuit in
the Pedelec.
Operating instructions
