CCpilot VS 12”
Product revision: A
Technical Manual
2017-11-23
www.crosscontrol.com
22
8
TR2+
6.8.
USB Type A connectors, general
USB type A connectors do not meet the
CCpilot VS 12”
IP-classification unless the rubber lid is
closed. There is an inner sealing to prevent water and dust to enter the device via the USB type A
connectors. However, the connector itself might be damaged by water and dust, so make sure the
rubber lids always are closed when not using the connectors.
If the rubber lids should be damaged contact the supplier for replacement parts.
6.9.
USB Type A pinout
Table 10: USB type A connector pinout
USB type A Connector
Matching plug:
male, 4-pin, type A
Pin
Signal
1
VBUS
2
Data-
3
Data+
4
Ground
7.
Specifications
7.1.
Technical data
Temperature specification
Operating
-30 to +70 °C
Storage
-30 to +80 °C
Kernel
Main Processor
NXP™ i.MX6: ARM 32-bit, 1 GHz, Automotive, Quad core, Cortex
®
-A9
Co-processor
STMicroelectronics STM32F373, Cortex
®
-M4
Data storage
4 Gbyte, Industrial grade eMMC
(Note)
RAM memory
2 Gbyte, DDR3
Note:
The eMMC is used in pseudo SLC mode and implements both static and dynamic wear levelling to
reach the best reliability. The number of program/erase cycles is between 20k to 60k depending on the
manufactures and temperature. Our recommendation for the application software is to temporary
cache in RAM and to write larger chunks of data to the eMMC. This recommendation is not specific to
eMMC but is applicable to all flash memories.
Power Supply
Supply voltage
Nominal
Extreme
12 V
DC
or 24 V
DC
7.5 V
DC
…32 V
DC
Power consumption
