CCpilot VS 12”
Product revision: A
Technical Manual
2017-11-23
www.crosscontrol.com
11
After cleaning, make sure that the device surface is left dry.
Never use high-pressure air, vacuum, water or steam to clean the device.
3.5.2.
Real time clock battery
Time and date information is stored in a memory sustained by an internal back-up battery.
The expected life time of the battery is approximately 20 years. The battery is not replaceable.
3.6.
Transportation
When transporting the device it is recommended to use the original packaging. Make sure that
protective caps are used on all non-mated connectors. The storage temperature interval [-30°C to
+80°C] must be met.
3.7.
Decommissioning
When the device has reached its end of life it should be handed over to the supplier or other
qualified party for recycling the product in an environmentally friendly manner. The manufacturer
does not handle decommissioning of the product.
4.
Basic operation
This section covers basic operation of the device such as start-up, shut-down, display operation and
status notification.
Observe that the behavior of the on/off controls (on/off button and key switch signal) is user
configurable.
Button backlight is used for status notification while starting up, shutting down or when the device
is in rescue mode. Both button backlight and the buzzer is software controllable for notifications
from user applications.
See chapter 4.4 for details of button backlight status notification.
The buzzer is used for audible alerts as well as for various error notifications, see chapter 4.5 for
error code details.
4.1.
Turning ON/OFF
The device can be turned ON or OFF from different actions as described in the following chapters.
To avoid data loss or corrupted flash memory, it is recommended that necessary data is saved and
user applications are properly closed before the device is shut down.
4.1.1.
Key switch signal
The factory default way of turning the device ON or OFF is by the use of the vehicle’s ignition
switch.
Turning the vehicle’s ignition key to position ON will start the device.
