CCpilot V1000/V1200
Revision: 1.0
Technical Manual
2022-04-01
www.crosscontrol.com
27
CCpilot V1200
Typical, operating
Max, operating
Suspend to RAM
Shutdown(wake on CAN)
Shutdown
* This assumes that the ignition signal is disconnected from supply voltage.
Vin = 12 V
DC
Vin = 24 V
DC
1.4A (typ)
670 mA (typ)
2.2A
1.2A
42 mA (typ) 23 mA (typ)
350 µA (typ) 200 µA (typ)
250 µA (typ)* 125 µA (typ)*
* This assumes that the ignition signal is disconnected from supply voltage.
Inrush current
CCpilot V1000
Duration ca 2 ms
CCpilot V1200
Duration ca 2 ms
Vin = 12 V
DC
Vin = 24 V
DC
< 2.4 A
< 2.4 A
< 2.4 A
< 2.4 A
External fuse recommendation
Current rating
2-3 A*
(including maximum external loads)
* This assumes that the fuse is in accordance with IEC 20127 i.e. can be continuously operated at
100% of rated current.
CAN interfaces
Type
Non-isolated, ISO 11898-1, CAN 2.0B
CAN transceiver
NXP TJA1051T/3
Baud Rate
Configurable 20 kbit/s – 1 Mbit/s.*
CAN FD mode up to 5 Mbit/s.
* Internal CAN bus filters have a capacitance of 100pF (typ) as stated in the J1939 specification. This
puts restrictions on the CAN bus topology considering bus length, number of CAN nodes etc. when
running at bit-rates higher than 250 kbps.
Protection
Short circuit protected to -36V to +36V
USB 2.0 interfaces
Type
1x USB 2.0 compatible host ports
Speed
Full-speed (12 Mbps) and Hi-speed USB (480 Mbps) is supported.
VBUS supply
5.0 V, 0.5 A per port, internally over-current (typically 0.7 A) and short-
circuit to ground protected.
USB 3.0 interfaces
Type
1x USB-C compatible host ports
Speed
Superspeed 5 Gbit/s
VBUS supply
5.0 V, 900mA, internally over-current (typically 1.25A) and short-circuit
to ground protected.
