crosscontrol CCpilot V1000, Technical Manual

Page: 19 / 33

CCpilot V1000/V1200 Revision: 1.0
Technical Manual 2022-04-01
www.crosscontrol.com 19
Error code Error code name Likely problem cause
0 ERR_NO_ERROR Default entry, log entry never written.
1 ERR_INVALID_LOG_ENTRY
Invalid log entry, i.e failed to read the
log entry from EEPROM.
2 - -
3 - -
4 ERR_LS_INIT Failed to initialize light sensor.
5 ERR_LS_I2C Failed to access light sensor over I2C.
6 ERR_EEPROM_INIT Failed to initialize eeprom.
7 ERR_DISP_ROT_AT_STARTUP
Failed to set display rotation at startup
(V1000 only).
8 ERR_RCC Failed to configure clocks.
9 ERR_TOUCH_I2C
Failed to access touch controller over
I2C.
10 ERR_TOUCH_NUM_CONTACTS Max number of contacts exceeded.
11 ERR_HID_START_TRANS_FAILED Failed to start a touch data transfer.
12 ERR_HID_RX_BUFF_OVERRUN I2C HID receive buffer overrun.
13 ERR_HID_REPORT_BUFF_OVERRUN Touch report buffer overrun.
14 ERR_MP_RX_BUFF_OVERRUN MP I2C receive buffer overrun.
15 ERR_MP_TX_BUFF_OVERRUN MP I2C transmit buffer overrun.
16 ERR_MP_RX_WR_BUFF_OVERRUN MP write buffer overrun.
17 ERR_MP_CMD_INVALID
Invalid/unknown command sent from
MP.
18 ERR_LOG_INIT
Failed to read out error log from
EEPROM.
19 ERR_EEPROM_DEFAULTS
Failed to write parameter default
values to EERPOM.
20 ERR_EEPROM_PARAM_WRITE_FAILED Failed to write EEPROM parameter.
21 ERR_EEPROM_PARAM_READ_FAILED Failed to read EEPROM parameter.
22 ERR_BL_OFF_SEQ Backlight OFF sequence failed.
23 ERR_BL_ON_SEQ Backlight ON sequence failed.
24 ERR_TFT_EN_SEQ TFT enable sequence failed.
25 ERR_TOUCH_EN_SEQ Touch enable sequence failed.
26 ERR_DISP_OFF_SEQ Display OFF sequence failed.
27 ERR_PARAM_BUFF_OVERRUN EEPROM parameter buffer overrun.
28 ERR_I2C_CALLBACK
Failed to register callbacks for I2C
transfer.
29 ERR_HID_IRQ_TIMEOUT Touch interrupt not cleared by MP.