15
14
(24) Operation identification (Not running)
(25) Battery (loss of) capacity
(26) Manual start information
(27) Battery (More than 8V / less than 10V)
(29) Fault identification
(30) Fault code symbol
(31) Maintenance identification
(28) Maintenance
NOTE
: The interface content of 23 is used for the MAC
address of connecting Bluetooth device.
The display interface can be switched by operation of key
7, and the contents are displayed in turn.
When the above contents are displayed in each display
interface, the contents of 8, 9 (displayed with Bluetooth,
not displayed without Bluetooth) and 10 are also displayed
at the same time.
4. When engine runs with failure: the screen interface
displays the contents of 29-30, and the content of 30
represents the fault information as follows:
U>
a: AC over voltage, indicating the character of AC
(alternative indication of AC and digit)
U<
a: AC under-voltage, indicating the character of AC
(alternative indication of AC and digit)
I>
Output over current of generator.
Output short circuit of generator.
Over heat of frequency converter.
NOTE
: When the above contents are displayed in each
display interface, the contents of 9 (displayed with
Bluetooth) and 10 are also displayed at the same time.
5. When the engine switch is in the “
ON”
position, and the
engine is either running or not, the screen interface will
display content 28 advising a service interval is required.
If the service has already been carried out , operate key 7
to clear this information.
NOTE
: Operate key 7 to clear the maintenance
information, the screen automatically switches to the next
interface.
If key 7 is not operated to clear the maintenance
information, the content of 28 will be displayed once every
1 minute in each screen interface for 10 seconds and the
content of 28 will not be displayed again until 2 hours
later. At the same time, the maintenance mark will not be
displayed on the right side of the Bluetooth mark on the
screen interface, until the generator set is maintained and
key 7 is operated to clear the maintenance information.
Oil Warning Light
When the oil level falls below
the low level, the oil warning
light comes on and then the
engine stops automatically.
Unless you refill with oil, the
engine will not start again.
NOTE
: If the engine stalls or does not start, turn the engine
switch to “
ON
” and then pull the recoil starter. If the oil
warning light flickers for a few seconds, the engine oil is
insufficient. Add oil and restart.
