25
24
Alternating Current (AC) Connection
WARNING: Be sure any electric devices are turned off
before plugging them in.
NOTICE
• Be sure all electric devices including the cable and plug
connections are in good condition before connection to
the generator.
• Be sure the total load is within generator rated output.
• Be sure the receptacle load current is within receptacle
rated current.
1. Start engine and make sure that AC indicator light is green.
2. Insert the plug into AC socket/
3. Make sure that AC indicator light is on.
4. Turn on the electrical equipment.
Many electric load devices require starting power above their
rated power to start.
The ESC throttle must be turned to “
Standard
” or “
Turbo”
before applying high start up loads.
• Some motorised appliances require more than their
electrical rating for startup. When an electrical motor is
started, the overload indicator (red) may come on. This
is normal if the overload indicator (red) goes off within 4
seconds. If the overload indicator (red) stays on, consult
your generator dealer.
• If the generator is connected to multiple loads or
electricity consumers, please remember to first connect
the one with the highest starting current. And last connect
the one with the lowest starting current.
• If the generator is overload, or if there is a short circuit in
a connected appliance, the overload indicator (red) will
go ON. The overload indicator (red) will stay ON, and after
about 4 seconds, current to the connected appliance (s)
will shut off, and the output indicator (green) will go OFF.
Stop engine and investigate the problem. Determine if
the cause is a short circuit in a connected appliance or an
overload, correct the problem and restart the generator.
MAINTENANCE
It is the owners requirement to periodically inspect, adjust,
lubricate and maintain the generator to keep it in good
working condition.
WARNING: Turn ENGINE SWITCH to “OFF” to avoid any
accidental start up during all maintenance procedures.
Stop the engine and allow the engine to cool before
starting maintenance work.
NOTE
: Use only genuine replacement parts, contact your local
authorised service agent.
NOTE
: Consult your local authorised service agent for all
major maintenance work.
Routine maintenance
cycle (1)
Each
check
First
months
or 20 Hr
3 months
or 50 Hr
6 months
or 100 Hr
12 months
or 300 Hr
Item
Routine
Oil
Inspect
●
Replace
●
●
Air filter
Inspect
●
Clean
●
(2)
Replace
●
*
Spark plug
Clean
Replace
●
Spark arrester
Clean
●
Valve
clearance
Inspect-
Adjustment
●
(3)
Combustion
chamber
Clean
Every 1000 hours (3)
Fuel tank
Clean
Every 2 years or 1000 hours (3)
Fuel filter
Replace
Every 2 years or 1000 hours (3)
Fuel hose
Clean
Every 2 years (Replacement if necessary) (3)
Tip
: *Replace the paper filter element.
Refueling
WARNING: Petrol is flammable and explosive.
When refueling you can get burns or serious injuries.
Before refuelling, stop engine
and allow to cool.
• Only refuel outdoors
• Clean up any spilled fuel
and allow to dry
• Do not over fill the fuel
tank. Only fill tank to red
full level indicator in the
fuel strainer.
NOTICE: Petrol can damage paint and plastics.
When refueling, take care not to spill petrol.
