18
GB/IE/NI
• Automatic return to the pilot (Fig. U)
Press the active button (2c) for about 3 seconds,
if the quadrocopter is to return via the same
route flown .
NOTE
Note that the return route can vary
as a result of the quadrocopter turning . The
process is brought to a halt via repeated
pressing of the button (2c), or via moving
the steering lever (2l) .
Setting the speed (Fig. O)
You can adjust the flight speed by repeatedly
pressing the throttles (2e, 2g) on the remote control
(2) . The default setting is speed 2, from a total of
four speed levels .
The display lights show the various levels (2j) .
Speed 1
(beep sounds once)
For first attempts with little flight experience .
Speed 2
(beep sounds twice)
For pilots with some experience .
Speed 3
(beep sounds three times)
For experienced pilots .
Speed 4
(beep sounds four times)
For very experienced pilots .
NOTE:
When the remote control is turned
off and on, the quadrocopter (1) is reset to
speed 2 .
360° Rollover (Fig. P)
1 . Fly the quadrocopter (1) to a height of approx .
10m .
2 . Keep it hovering and press the control button(2k)
once, which can be found on the front of the
remote control . A signal tone is emitted and the
FLIP light is shown on the display (2j) .
3 . Move the control lever (2l) in the direction in
which the rollover is to be performed .
4 . The quadrocopter (1) will perform a 360° rollo-
ver .
After the rollover, the quadrocopter (1) will be in
normal flight mode and you can perform another
rollover .
Repeat steps 1-4 to do so .
Press the button (2k) again if you do not want to
perform a rollover, yet you had already pressed it .
CAUTION:
You need sufficient flight
altitude for a 360° rollover (at least 10m) .
Calibration
There are instances when the quadrocopter (1) flies
erratically and needs to be calibrated . In such a
case, follow the steps below:
1 . Place the quadrocopter (1) on a horizontal, level
surface .
2 . Switch the remote control (2) on and simultane-
ously push the throttle (2h) backwards and to
the left and the joystick (2l) backwards and to
the right . The control lights (1h) on the quadro-
copter (1) will flash for approx . 3 seconds . Once
the control lights (1h) light up continuously, the
calibration is complete and the quadrocopter is
ready to fly .
NOTE:
Repeat the calibration if the quadro-
copter still flies erratically in one direction .
Recording data (Fig. S)
Photographs or videos can be taken with the
camera .
NOTE:
Remove the protective covering from
the lens before using it for the first time .
Photos
1 . Press the camera button (2b) once .
2 . A signal tone is emitted, and on the display (2j)
the CAMERA light lights up and the LED lights
(1h) of the quadrocopter (1) stop lighting up for
a short time . This indicates that the camera (1e)
has taken a photo .
Video
1 . Hold the camera button (2b) down for approx .
3 seconds .
2 . A signal tone is emitted, and the LED lights (1h)
on the quadrocopter (1) blink . This indicates that
the camera (1e) is filming .
3 . Press the video capture button (2b) again to stop
filming with the camera (1e) . A signal tone is
emitted as confirmation, and the LED lights (1h)
on the quadrocopter (1) light up continuously .
